MP-1xx SIP
MP-1xx SIP User’s Manual 234 Document #: LTRT-65404
Safety Notice
Installation and service of this card must only be performed by authorized, qualified service personnel.
The protective earth terminal on the back of the MP-1xx must be permanently connected to protective earth.
Telecommunication Safety
The safety status of each port on the gateway is declared and detailed in the table below:
Ports Safety Status
Ethernet (100 Base-TX) SELV
FXS (ODP P/N’s) TNV-3
FXS TNV-2
TNV-3: Circuit whose normal operating voltages exceeds the limits for an SELV circuit under normal operating conditions
and on which over voltages from Telecommunication Networks are possible
TNV-2: Circuit whose normal operating voltages exceeds the limits for an SELV circuit under normal operating conditions
and is not subjected to over voltages from Telecommunication Networks
SELV: Safety extra low voltage circuit.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
H.2 MP-11x FXO
Declaration of Conformity
Application of Council Directives: 73/23/EEC (including amendments),
89/336/EEC (including amendments),
1999/5/EC Annex-II of the Directive
Standards to which Conformity is Declared: EN55022: 1998, Class B
EN55024:1998
EN61000-3-2: 1995
(including amendments A1: 1998, A2: 1998, A14: 2000)
EN61000-3-3: 1995
EN60950: 2000
TBR-21: 1998
Manufacturer’s Name: AudioCodes Ltd.
Manufacturer’s Address: 1 Hayarden Street, Airport City, Lod 70151, Israel.
Type of Equipment: Analog VoIP System.
Model Numbers: MP-1xx/FXO
(xx- may represent 02, 04, 08)
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directives and Standards.
11
th
February 2005 Airport City, Lod, Israel
Signature Date (Day/Month/Year) Location
I. Zusmanovich, Compliance Engineering Manager
To Next Page
Loading...
Need help?
General
