Cisco 7925G User Manual

Instructions for accessing Push to Talk depend on your system:
•
for systems using Cisco Unified Communications Manager Release 4.3 or later, see Phone Services
Subscriptions, on page 126
•
for systems using Cisco Unified Communications Manager Release 5.0 or later, see Phone Services
Setup on Web, on page 134
Use Push to Talk Service
Procedure
Step 1
Choose > Push to Talk (name can vary).
Push to Talk service is active when the icon appears.
Step 2
Use the button to start and end a transmission depending on how your service is configured.
Step 3
Use the Talk and Stop softkeys to toggle between transmitting and listening.
Java MIDlets
Java MIDlets are special applications that provide you with specific services. An example of a MIDlet would
be the Bar Code Scanner application that is used by the Cisco Unified Wireless IP Phone 7926G.
To use a MIDLet, you need to subscribe to the service. To access a MIDlet, you press the Applications button
(on the left side of the phone).
Your administrator can set up a MIDlet to automatically launch when you turn on the phone. The MIDlet
starts and then minimizes to the background until you need to use it.
You can manually stop the launched MIDlet. To start the MIDlet later, you either launch the MIDlet or turn
the phone off and on.
For more information, contact your system administrator.
Bar Code Scanner
Your system administrator can configure the Cisco Unified Wireless IP Phone 7926G to scan bar codes using
the scanning module on the top of the phone. The phone uses a Java MIDlet to read the bar code data and
display information such as pricing, location, and inventory information. Contact your system administrator
for information about using the bar code scanner.
The Cisco Unified Wireless IP Phone 7926G must be running Firmware Version 1.4(1) or later to support
the bar code scanner.
Note
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G User Guide
91
Applications
Java MIDlets

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g