Cisco Nexus 7000 User Manual

8-43
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Appendix 8 Managing the Switch Hardware
Configuring EPLDs
The following example shows Release 186.008 on the FE Bridge line, which is the correct EPLD
version:
Nexus-7k(config)# show version module 7 epld
EPLD Device Version
-----------------------------------------
Power Manager 4.008
IO 1.016
Forwarding Engine 1.006
FE Bridge(1) 186.008 << OK!
FE Bridge(2) 186.008 << OK!
Linksec Engine(1) 2.007
Linksec Engine(2) 2.007
Linksec Engine(3) 2.007
Linksec Engine(4) 2.007
Linksec Engine(5) 2.007
Linksec Engine(6) 2.007
Linksec Engine(7) 2.007
Linksec Engine(8) 2.007
EPLD Images Needed for LISP
The Locator/ID Separator Protocol ( LISP) feature is available beginning with Cisco NX-OS Release
5.2(1). When you enable LISP on the chassis, you must have EPLD image 186.8 or 186.008 (or later
image) on the 32-port 10-Gigabit Ethernet types of I/O modules (N7K-M132XP-12 and
N7K-M132XP-12L).
Note The EPLD upgrade operation is a disruptive operation. You should execute this operation only at a
programmed maintenance time. The system/kickstart ISSU upgrade is a nondisruptive upgrade.
If you are working with an N7K-M132XP-12 module that was shipped before July 2011, you might need
to upgrade the EPLD version.
To determine the EPLD version for all N7K-M132XP-12 and N7K-M132XP-12L modules, enter the
show version module slot_number epld. If the line FE Bridge(x) version displays a version earlier than
186.8 or 186.008, you should schedule an EPLD upgrade to a version that is compatible with the target
Cisco NX-OS release. For example, if you want to run Cisco NX-OS Release 5.2(1), you should choose
Release 5.2(1) EPLDs.
The following example shows Release 186.008 on the FE Bridge line, which is the correct EPLD
version:
Nexus-7k(config)# show version module 7 epld
EPLD Device Version
-----------------------------------------
Power Manager 4.008
IO 1.016
Forwarding Engine 1.006
FE Bridge(1) 186.008 << OK!
FE Bridge(2) 186.008 << OK!
Linksec Engine(1) 2.007
Linksec Engine(2) 2.007
Linksec Engine(3) 2.007
Linksec Engine(4) 2.007
Linksec Engine(5) 2.007

Cisco Nexus 7000 Specifications

General

Chassis Type	Modular
Product Type	Switch
Power Supply	AC or DC
Cooling	Redundant, hot-swappable fan trays
Management	CLI, SNMP
Form Factor	Modular chassis
Interfaces/Ports	Varies by module
Product Series	Nexus 7000
Port Density	Varies by module
Redundancy	Power supply, fan, supervisor engine
Management Interfaces	Console, Ethernet
Security Features	ACLs, port security
Virtualization Support	VRF
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 95% non-condensing