Cisco Nexus 7000 User Manual

10-43
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 10 Installing or Replacing Components
Installing a NAM Module
Step 1 Use a browser to go to http://software.cisco.com/download/navigator.html.
The Software Download page opens.
Step 2 Choose Cloud and Systems Management > Network Analysis Module (NAM) Products > Cisco
Prime Network Analysis Module Software > Cisco Prime Network Analysis Module Software 6.2
(or later verssion). A list of software files appears.
Step 3 Click the Download button for the software file name beginning with nam-nx1. The filename is
nam-nx1.x-x-x.bin.gz (where x-x-x is the NAM software release number).
Step 4 Using the NAM CLI, enter the upgrade command to specify the user, password, server,path to the file,
and installation file name. For example, for the admin user, “secret” password, server IP address
10.10.10.10, archive/nam_software path, and nam-nx1.6.0.1.bin.gz installation file, you would use the
upgrade command as follows:
upgrade ftp://admin:secret!10.10.10.10//archive/nam_software/nam-nx1.6.0.1.bin.gz
Configuring the NAM
To configure the NAM software, you must do all of the following:
• Configure the VLAN management port from the switch (see the “Configuring a VLAN Management
Port for the NAM” section on page 10-43).
• Configure the SPAN session from the switch (see the “Configuring a SPAN Session for a Data Port”
section on page 10-44).
• Set up the NAM network configuration for the NAM (see the “Specifying the NAM IP Configuration
and Enabling the Web Server” section on page 10-46).
Configuring a VLAN Management Port for the NAM
Using the virtual device context (VDC) that the NAM belongs to, you must configure a VLAN for NAM
management traffic, and you must assign that VLAN to the NAM management port.
To configure and assign a VLAN management port, follow these steps:
Step 1 Verify that the NAM is active.
switch# show service nam summary
Service Service
Name Type Interface Module State Version
---------------- ----------- -------------- --------- --------- ---------------
NAM7 NAM Po4096, Po4095 7 active 6.0
Step 2 Allocate the NAM interfaces to the VDC as follows:
• If you are using the default VDC configuration, the NAM interfaces should be allocated to the
default VDC automatically. Verify that allocation.
switch(config)# show run vdc
!Command: show running-config vdc
!Time: Wed May 29 18:47:17 2013
version 6.2(2)
no system admin-vdc
vdc N7K-8 id 1

Cisco Nexus 7000 Specifications

General

Chassis Type	Modular
Product Type	Switch
Power Supply	AC or DC
Cooling	Redundant, hot-swappable fan trays
Management	CLI, SNMP
Form Factor	Modular chassis
Interfaces/Ports	Varies by module
Product Series	Nexus 7000
Port Density	Varies by module
Redundancy	Power supply, fan, supervisor engine
Management Interfaces	Console, Ethernet
Security Features	ACLs, port security
Virtualization Support	VRF
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 95% non-condensing