116 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
The Current Status of the plan shows one of the following states:
• None—The power adjustment algorithm has not been manually run since the last switch
reboot.
• Algorithm In Progress—The power adjustment algorithm is running.
• Algorithm Complete—The power adjustment algorithm has finished running.
A table displays to indicate proposed power adjustments. Each entry shows the AP along
with the current and new power levels. To accept the proposed change, click Apply. You
must manually apply the power adjustment for the proposed assignments to be applied.
• Apply In Progress—The switch is adjusting the power levels that the APs use.
• Apply Complete—The algorithm and power adjustment are complete.
Upgrading the Access Point Software
The D-Link Unified Switch can upgrade software on the APs that it manages. To upgrade one
or more D-Link Access Point from the switch that manages it, click the WLAN > AP
Management > Software Downloads tab.
Figure 54. AP Upgrade
NOTE:The APs automatically reset after the code is successfully downloaded.
Table 19 describes the fields you must complete to upgrade D-Link Access Points.
Table 19. AP Upgrade
Field Description
Server Address Enter the IP address of the host where the upgrade file is located. The host
must have a TFTP server installed and running.
File Path Enter the path to the directory where the upgrade file is located. You may
enter up to 96 characters.
To Next Page
Loading...
Need help?
General
