88 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
NOTE:The radio settings for the IEEE 802.11g radio are directly below the settings
for the IEEE 802.11a radio.When the profile is applied to the DWL-3500AP,
only the settings for the IEEE 802.11g radio are applied.
Figure 38. Radio Settings
The following table describes the fields you can configure from the Radio tab on the Basic
Setup page. After you change the settings, click Submit to apply the settings.
Table 9. Radio Settings
Field Description
State Specify whether you want the radio on or off by clicking On or Off.
If you turn off a radio, the AP sends disassociation frames to all the wireless
clients it is currently supporting so that the radio can be gracefully shutdown
and the clients can start the association process with other available APs.
Super A
Super G
Super A and Super G attempt to increases performance through bursting and
frame compression. Performance increases when the AP communicates with
Super A and Super G-enabled clients. However, with Super A and Super G
enabled, the access point transmissions consume more bandwidth.
• To enable Super A or Super G, select Enabled.
• To disable Super A or Super G, select Disabled.
• To enable Super A or Super G with Dynamic Turbo, select Enable with
Dynamic Turbo.
To Next Page
Loading...
Need help?
General
