Default D-Link Access Point Profile Settings 205
D-Link Unified Access System Default Settings
Default D-Link Access Point Profile Settings
Table 78 shows the AP settings for the default profile. By default, when a D-Link Access Point
associates with the switch, the settings in this table are assigned to the AP upon successful AP
validation.
Table 78. AP Profile Default Settings
Feature Default
Radio Settings
Radio (1 and 2) On
Radio 1 IEEE 802.11 Mode 802.11a
NOTE: If the AP operates in a regulatory domain
where 802.11a is not supported, the radio is disabled
and no mode is configured.
Radio 2 IEEE 802.11 Mode 802.11b/g
RF Scan Other Channels Disabled
RF Scan Interval 60 seconds
RF Scan Duration 10 milliseconds
Super A/G Disabled
Extended Range Disabled
Automatic Channel Enabled
Automatic Power Enabled
Initial Power 100
Load Balancing Disabled
Load Utilization 60%
Maximum Clients 256
RTS Threshold 2347 bytes
DTIM Period 10 beacons
Fragmentation Threshold 2346 bytes
Beacon Period 100 milliseconds
Rate Sets
Supported (Mbps)
IEEE 802.1a: 54, 48, 36, 24, 18, 12, 9, 6
IEEE 802.1g: 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1
IEEE 802.1b: 11, 5.5, 2, 1
Atheros Dynamic Turbo 5 GHz: 108, 96, 72, 48, 36, 24,
18, 12
Rate Sets (Mbps)
(Basic/Advertised)
IEEE 802.1a: 24, 12, 6
IEEE 802.1g: 11, 5.5, 2, 1
IEEE 802.1b: 2, 1
Atheros Dynamic Turbo 5 GHz: 48, 24, 12
To Next Page
Loading...
Need help?
General
