56 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
To view the network information, enter show network.
6. To save these changes so they are retained during a switch reset, enter the following
command:
write
Once the D-Link Unified Switch is connected to the network, you can use the IP address for
remote access to the switch by using a Web browser or through Telnet or SSH.
Enabling the WLAN Features on the Switch
In order for the Unified Switch to be able to discover and manage access points, the WLAN
switch and its operational status must both be enabled. The WLAN component is enabled by
default.
When you access the switch user interface, make sure you set the correct country code for the
switch so that the access points can only operate in the modes permitted in your country. The
default country code is US for operation in the United States.
To set the country code and enable the switch by using the Web interface, click
Administration > Basic Setup. Table 3 describes the fields on the Wireless Global
Configuration page.
NOTE:Wireless features are available under the WLAN tab on the navigation menu.
NOTE:Most configuration pages have a Submit button, which applies the changes to
the running configuration but does not save them to non-volatile memory
(NVRAM). To make the changes permanent so they persist across a reboot,
click the Tool, then click Save Changes to navigate to the appropriate page.
You can also use the
write command in Privileged Exec mode.
Table 3. Basic Wireless Global Configuration
Field Description
Enable WLAN
Switch
Check the box to enable WLAN switching functionality on the system. Clear
the check box to administratively disable the WLAN switch.
If you clear the check box, all peer switches and APs that are associated with
this switch are disassociated.
Disabling the WLAN switch does not affect non-WLAN features on the
switch, such as VLAN or STP functionality.
WLAN Switch
Operational Status
Shows the operational status of the switch. The status can be one of the
following values:
•Enabled
• Enable-Pending
•Disabled
• Disable-Pending
If the status is pending, click Refresh to refresh the screen.
To Next Page
Loading...
Need help?
General
