Configuring the Captive Portal 169
9 Configuring the Captive Portal
Configuring the Captive Portal
Use the CP Summary page to create or delete captive portal configurations. The switch
supports 10 CP configurations. CP configuration 1 is created by default and can not be deleted.
Each captive portal configuration can have unique guest or group access modes and a
customized acceptance use policy that displays when the client connects.
To view summary information about existing captive portals, or to add or delete a captive
portal, click Security > Captive Portal > CP Configuration.
Figure 77. Captive Portal Summary
To create a CP configuration, enter the configuration name in the text box and click Add.
After you add the configuration, the CP Configuration page for that configuration displays,
and a new tab with the name of that configuration appears.
To delete an existing CP, select the check box for the CP to remove, and then click Delete.
To configure the settings for an existing CP, click the name in the Configuration column or
click the appropriate tab.
Table 57 describes the fields on the CP Summary page.
Table 57. Captive Portal Summary
Field Description
Configuration Shows the captive portal ID and name. To access the configuration page for
an exiting CP, click the configuration name.
Mode Shows whether the CP is enabled.
To Next Page
Loading...
Need help?
General
