118 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
Table 20 describes the fields that appear after you start the AP upgrade process.
A table also appears and lists each AP, its download status, and the software version it is
downloading. The status for an individual AP can have one of the following values:
• Requested—Download has been requested for this AP.
• Success—The AP reported successful code download.
• Failure—The AP reported a failed code download.
• Code Transfer In Progress—The code download to the AP is in progress.
• NVRAM Update In Progress—The AP NVRAM is being updated.
• Waiting for APs to Download—The code transfer is complete, but the AP is waiting for
the remaining APs to finish downloading and then it will start updating its NVRAM.
• Aborted—The upgrade of the AP was aborted.
Table 20. AP Upgrade Status
Field Description
Download Status This field shows the status of the upgrade process for all APs:
• Not Started—The Unified Switch has not started the download process.
• Requested—A request to download AP software has been made, but the
switch has not done any downloads.
• In Progress—The AP is currently attempting to download software from
the server.
• Success—Download completed successfully on all APs. An AP reports
a successful download to the switch after the software transfers from the
TFTP server to the AP and the code checksum is good. The code must
also match the intended hardware platform.
• Failure—Download failed on all APs. A software download fails if the
AP reports a software download failure due to an inability to contact the
TFTP server or find the upgrade file, or if the AP loses connectivity with
the switch.
Download Count The number in this field shows the number of managed APs to download
software in the current download request. If you selected All for the managed
APs to upgrade, the download count shows the number of managed APs at
the time the download request was started. The value is 1 if only one AP is
being updated.
Success Count The number in this field shows the number of APs that have successfully
downloaded the new code. This value starts with 0 at the beginning of the
download and increases by one for every AP that successfully downloaded
the code.
Failure Count The number in this field shows the number of APs that failed to download
the new code. This value starts with 0 at the beginning of the download and
increases by one for every AP that failed to downloaded the code.
To Next Page
Loading...
Need help?
General
