226 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
To configure BootP and DHCP relay from the Web interface on the switch, go to the
L3 Features > BootP/DHCP Relay Agent > Configuration page. Configure the server IP
address and enable the Admin Mode, then click Submit.
Configuring the DHCP Server
To configure DHCP on the D-Link Unified Switch, you configure the global DHCP settings
and the address pool for the clients. The following example shows how to create an address
pool for the wireless clients on the L3 Tunnel network. You can create additional address pools
so that the DHCP server on the Unified Switch can serve IP addresses to wireless clients that
use other networks (such as the Guest Network or Corporate LAN).
The following commands show how to configure a DHCP server to use for the wireless clients
that connect to the L3 Tunnel wireless network.
1. From Global Config mode, enable DHCP.
(switch-prompt) (Config)#service dhcp
2. Exclude the IP addresses in the range of 192.168.60.1 through 192.168.60.50, which
includes the IP addresses of WS1, WS2, and the Call Server.
(switch-prompt) (Config)#ip dhcp excluded-address 192.168.2.201
192.168.2.255
3. Create an address pool.
(switch-prompt) (Config)#ip dhcp pool vlan200
4. Configure the L3 Tunnel subnet and netmask as the network address for the clients on
VLAN 200.
(switch-prompt) (Config)network 192.168.60.0 255.255.255.0
5. Configure the default router for the address pool.
(switch-prompt) (Config)default-router 192.168.60.1
To Next Page
Loading...
Need help?
General
