180 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
Table 65 describes the information that displays for each portal.
The following buttons are available on the CP Activation and Activity page:
• Block—Click Block to prevent users from gaining access to the network through the
selected captive portal.
• Unblock—If the Blocked Status of the selected captive portal is Blocked, click Unblock
to allow access to the network through the captive portal.
• Refresh—Click Refresh to update the screen with the most current information.
Table 65. CP Activation and Activity Status
Field Description
Operational Status Indicates whether the captive portal is enabled or disabled.
Disable Reason If the captive portal is disabled, then this field indicates the reason. The
portal instance may be disabled for the following reasons:
• None - CP is enabled.
• Administratively Disabled
• RADIUS Authentication mode enabled, but RADIUS server is not
defined.
• Not associated with any interfaces.
• The associated interfaces do not exist or do not support the CP
capability.
Blocked Status Indicates whether authentication attempts to the captive portal are currently
blocked.
Use the Block and Unblock buttons to control the blocked status. If the CP is
blocked, users cannot gain access to the network through the CP. Use this
function to temporarily protect the network during unexpected events, such
as denial of service attacks.
Note: The Blocked Status is the operational status and not the configured
status. It does not persist over a reboot. By default, the status is unblocked.
Block and Unblock are only available when the CP operational status is
Enabled.
Authenticated
Users
Shows the number of users that successfully authenticated to this captive
portal and are currently using the portal.
To Next Page
Loading...
Need help?
General
