User's Manual
197
Step 3 Click again to stop calling the tour.
4.4.4.3 Calling Patterns
Procedure
Step 1 On the expanded PTZ control panel, in the
No.
box, enter the value of the pattern that you
want to call.
Step 2 Call to call the pattern.
Step 3 The PTZ camera moves according to the configured pattern repeatedly.
Step 4 Click again to stop calling the pattern.
4.4.4.4 Calling AutoScan
Procedure
Step 1 On the expanded PTZ control panel, in the
No.
box, enter the value of the border that you
want to call.
Step 2 Click .
Step 3 The PTZ camera performs scanning according to the configured borders.
Step 4 Click again to stop auto scanning.
4.4.4.5 Calling AutoPan
Procedure
Step 1 On the expanded PTZ control panel, click to start moving in horizontal direction.
Step 2 Click again to stop moving.
4.4.4.6 Using Auxiliary Button
On the expanded PTZ control panel, click , the AUX setting interface is displayed. See Figure 4-96.
In the
Shortcut Aux
list, select the option that corresponds to the applied protocol.
In the
Aux No.
box, enter the number that corresponds to the AUX switch on the decoder.
To Next Page
Loading...
Need help?
General
