User's Manual
353
Figure 4-236
Step 2 Enable the P2P function.
After the P2P function is enabled and connected to the Internet, the system will collects
your information for remote access, and the information includes but not limited to email
address, MAC address, and device serial number.
You can start adding the device.
●
Cell Phone Client: Use your mobile phone to scan the QR code to add the device into
the Cell Phone Client, and then you can start accessing the Device.
●
Platform: Obtain the Device SN by scanning the QR code. Go to the P2P management
platform and add the Device SN into the platform. Then you can access and manage
the device in the WAN. For details, refer to the P2P operation manual.
You can also enter the QR code of Cell Phone Client and Device SN by clicking on the
top right of the interfaces after you have entered the Main Menu.
4.11.17.1 Mobile APP Operation
Background Information
The following contents are introduced in the example of mobile App.
Procedure
Step 1 Scan the QR code to download and install the mobile App.
Step 2 Select Camera and enter the main interface.
Step 3 Register device in the mobile App:
1) Click and select Device Manager. See Figure 4-237.
To Next Page
Loading...
Need help?
General
