Dahua NVR41-4KS2 Series User Manual

User's Manual
351
Table 4-78
Function Description
Enable Enable the register function.
Server IP Address
Enter the server IP address or the server domain that you want to
register to.
Port Enter the port of the server.
Sub Service ID This ID is allocated by the server and used for the Device.
Step 3 Click
Apply
to complete the settings.
4.11.16 Setting Switch
Background Information
After setting
Switch
, when an IPC is connected to the PoE port, the system automatically assigns the
IP address to the IPC according to the set IP segment, and the NVR will automatically connect to the
IPC.
●
Only models with PoE ports support this function.
●
Do not connect the PoE port with a switch, otherwise it will cause connection failure.
●
This function is enabled by default, and the IP segment start from 10.1.1.1, we recommend that
you use the default setting.
●
When connecting to a third-party IPC, make sure that the IPC supports Onvif protocol and DHCP
is enabled.
Procedure
Step 1 Select
Main Menu
>
Network
>
Switch
.
Figure 4-235
Step 2 Set the values of
IP Address
,
Subnet Mask
and
Default Gateway
.
Do not set the value of
IP Address
to the same network segment with the NVR, we

Dahua NVR41-4KS2 Series Specifications

General

Brand	Dahua
Model	NVR41-4KS2 Series
Category	Network Hardware
Language	English