EMC Data Domain DS60 User Manual

Remove the bezel.......................................................................................................59
Remove chassis bracket from chassis........................................................................ 60
Remove the chassis bracket.......................................................................................60
Unclip the cable chains from the tray..........................................................................61
Push spring clips up to release the tray.......................................................................61
Remove the tray.........................................................................................................62
Screw and nut placements......................................................................................... 63
18"-22" marking..........................................................................................................64
26"-30" Marking........................................................................................................ 65
30"-34" Marking........................................................................................................ 65
Rail installation........................................................................................................... 68
Securing a rail with a single screw ............................................................................. 70
Location of securing screws and alignment pins ......................................................... 71
Nutbar installation (Left nutbar shown)......................................................................73
Removing the universal rails....................................................................................... 74
Opening the console...................................................................................................89
Removing the front bezel .......................................................................................... 90
Pulling the Chassis Out (Two shoulder Screw Configuration)..................................... 91
Removing a disk drive.................................................................................................92
Installing a disk........................................................................................................... 93
Removing the front bezel .......................................................................................... 95
Pulling the Chassis Out (Two shoulder Screw Configuration).................................... 96
Reconfiguring the portable lift with the Voyager conversion kit ................................101
Adjusting the lift arm bar to just under 17 inches ...................................................... 102
Opening the console..................................................................................................104
Removing the front bezel .........................................................................................105
Removing a disk drive............................................................................................... 105
Example of adjusting the lift arm/tray to just under 17-inches.................................. 108
Releasing chassis from the rails................................................................................ 109
Removing the shipping screws, if present................................................................. 109
Pulling the chassis out (two shoulder screw configuration)....................................... 110
Reconfiguring the Alum-A-Lift with the conversion kit.............................................. 110
Locking the casters.................................................................................................... 111
Removing a shelf from rails more than 49" above the floor .......................................112
Tightening the straps.................................................................................................113
Unlocking the casters................................................................................................ 113
Reconfiguring the portable lift with the Voyager conversion kit ................................115
Adjusting the lift arm bar to just under 17 inches .......................................................116
Sliding the shelf chassis into the rails ........................................................................118
Unlocking the casters................................................................................................ 118
Locking the casters....................................................................................................119
Removing the straps..................................................................................................119
Inserting and securing the chassis to the cabinet...................................................... 120
Inserting and Securing the Chassis to the Cabinet (Shoulder Screw Configuration)
.................................................................................................................................. 121
Removing semi-captive screws..................................................................................121
Installing ears to rack using truss head screws.......................................................... 122
Installing top cover using truss head screws..............................................................123
Removal of semi-captive screws............................................................................... 124
Installing a disk..........................................................................................................126
Removing the front bezel ......................................................................................... 129
Remove the bezel......................................................................................................129
Installing the bezel.................................................................................................... 130
Remove the bezel......................................................................................................130
Remove chassis bracket from chassis........................................................................131
Remove the chassis bracket...................................................................................... 131
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
FIGURES
8 EMC Data Domain DS60 Expansion Shelf Installation and FRU Replacement Hardware Guide

EMC Data Domain DS60 Specifications

General

Brand	EMC
Model	Data Domain DS60
Category	Server
Language	English