Fujitsu 8FX User Manual

MB95630H Series
MN702-00009-2v0-E FUJITSU SEMICONDUCTOR LIMITED 331
CHAPTER 18 8/16-BIT PPG
18.8 Notes on Using 8/16-bit PPG
18.8 Notes on Using 8/16-bit PPG
This section provides notes on using the 8/16-bit PPG.
■ Notes on Using 8/16-bit PPG
● Note on operation
Depending on the timing between the activation of PPG and count clock, an error may occur in
the first cycle of the PPG output immediately after the activation. The error varies depending
on the count clock selected. The output, however, is performed properly in the succeeding
cycles.
● Note on interrupts
A PPG interrupt is generated when the interrupt enable bit (PIE1/PIE0) is set to "1" and the
interrupt request flag bit (PUF1/PUF0) in the 8/16-bit PPG timer n1/n0 control register (PCn1/
PCn0) is also set to "1". Always clear the interrupt request flag bit (PUF1/PUF0) to "0" in the
interrupt service routine.

Fujitsu 8FX Specifications

General

Brand	Fujitsu
Model	8FX
Category	Computer Hardware
Language	English