HEIDENHAIN ITNC 530 Service Manual

July 2010 30 – 587
MP1087.x Maximum permissible axis-specific jerk for "Manual mode"
Input: 0.1 to 1000.0 [m/s³ or 1000 °/s³]
PLC
RUN
MP1088.x Axis-specific jerk limiting for unfiltered positioning movements
Input: 0.1 to 9999.9 [m/s³]
340 490-05
MP1089.x Max. permissible axis-specific jerk for "Pass Over Reference Point" mode
Input: 0.1 to 1000.0 [m/s³ or 1000 °/s³]
PLC
RUN
MP1090 Maximum permissible jerk on the tool path
Input: 0: Not active
0.0 to 9999.9 [m/s³ or °/s³]
PLC
RUN
340 490-04
MP1090.0 For movements not at rapid traverse or feed rate < MP1092
MP1090.1 For movements at rapid traverse or feed rate > MP1092
MP1092 Feed rate threshold for MP1085.x and MP1086.x
Input: 1 to 300 000 [mm/min] (previous behavior)
0: Not active
PLC
RUN
340 490-03
MP1094 HSC filters
Input: 0: HSC filter inactive
0.1 to 166.0: Cutoff frequency for HSC filter
As of
340 490-01,
340 492-01
only via
MPMODE =
340422 in
OEM.SYS
MP1095 Nominal position value filter
Input: 0: Single filter
1: Double filter
PLC
RUN
As of
340 490-01,
340 492-01
only via
MPMODE =
340422 in
OEM.SYS
MP1095.0 In the Program Run Full Sequence, Program Run Single Block, and Positioning With
Manual Data Input operating modes
MP1095.1 In the Manual, Handwheel, Jog Increment and Pass Over Reference Point operating
modes
MP1096 Tolerance for contour transitions at corners
Input: 0: No nominal position value filter
0.001 to 3.000 [mm]
PLC
RUN
As of
340 490-01,
340 492-01
only via
MPMODE =
340422 in
OEM.SYS
MP1096.0 With machining feed rate
MP1096.1 With rapid traverse
MP1097.x Maximum permissible axis-specific jerk (single/HSC filter)
Input: 0.1 to 1000.0 [m/s³ or 1000 °/s³]
PLC
RUN
As of
340 490-01,
340 492-01
only via
MPMODE =
340422 in
OEM.SYS
MP Function and input SW version
and
behavior

HEIDENHAIN ITNC 530 Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530
Category	Control Systems
Language	English