Hitachi ZAXIS 30U-5N User Manual

OPERATOR'S STATION
1-37
Trip
Functions of Trip Meter
Thetripmeterallowstheoperatortoknowthatthe
machine operation hours has reached the preset hours by
blinkingtheTripmark(Trip1orTrip2).TheTripmarkblinks
for30secondswhenthemachineoperationhourreaches
thepresethours.Afterthat,everytimethekeyswitchis
turnedON,theTripmeterblinksfor30secondsuntilthe
meter is reset.
IMPORTANT: This "Operation Hour" means the machine
operation time counted from the point at which
the Trip meter is set. It is different from the "Total
Accumulated Machine Operation Time" displayed on
the hour meter.
f
NOTE: Once the Trip meter is set, it will continuously count
the machine operation time regardless of the LCD display
status. When the machine operation hour reaches the preset
hours, the Trip mark on LCD display (1) blinks.

If Trip mark is displayed on the monitor screen when the Trip
mark starts blinking, the Trip mark stays ON after blinking.
If the Trip mark is not displayed on the monitor screen when
the Trip mark starts blinking, the Trop mark goes OFF after
blinking.
IftheTripmarkisnotused,setsufficientlylongtime.
(Example:3000h)
f
NOTE: The trip meter is set 9999.9h when the machine is
shipped from the factory.
1
2
Trip Meter
TripMark
MADH-01-036

Hitachi ZAXIS 30U-5N Specifications

General

Brand	Hitachi
Model	ZAXIS 30U-5N
Category	Excavators
Language	English