345
Views
IPsec policy view, IPsec profile view
Predefined user roles
network-admin
Parameters
inbound: Specifies an SPI for inbound SAs.
outbound: Specifies an SPI for outbound SAs.
ah: Uses AH.
esp: Uses ESP.
spi-number: Specifies a security parameters index (SPI) in the range of 256 to 4294967295.
Usage guidelines
This command applies to only manual IPsec policies and IPsec profiles.
You must configure an SPI for both inbound and outbound SAs, and make sure the SAs in each direction
are unique: For an outbound SA, make sure its triplet (remote IP address, security protocol, and SPI) is
unique. For an inbound SA, make sure its SPI is unique.
The local inbound SA must use the same SPI as the remote outbound SA, and the local outbound SA must
use the same SPI as the remote inbound SA.
When you configure an IPsec policy or IPsec profile for an IPv6 routing protocol, follow these guidelines:
• The local inbound and outbound SAs must use the same SPI.
• The IPsec SAs on the devices in the same scope must have the same key. The scope is defined by
protocols. For OSPF, the scope consists of OSPF neighbors or an OSPF area. For RIPng, the scope
consists of directly-connected neighbors or a RIPng process. For BGP, the scope consists of BGP
peers or a BGP peer group.
Examples
# Set the SPI for the inbound SA to 10000 and the SPI for the outbound SA to 20000 in a manual IPsec
policy.
<Sysname> system-view
[Sysname] ipsec policy policy1 100 manual
[Sysname-ipsec-policy-manual-policy1-100] sa spi inbound ah 10000
[Sysname-ipsec-policy-manual-policy1-100] sa spi outbound ah 20000
Related commands
display ipsec sa
sa string-key
Use sa string-key to set a key string (a key in character format) for manual IPsec SAs.
Use undo sa string-key to remove the key string.
Syntax
sa string-key { inbound | outbound } { ah | esp } [ cipher | simple ] string-key
undo sa string-key { inbound | outbound } { ah | esp }
To Next Page
Loading...
Need help?
General
