527
Views
System view
Predefined user roles
network-admin
Parameters
threshold-value: Specifies the threshold for source MAC-based ARP attack detection. The value range is
1 to 5000.
Examples
# Configure the threshold for source MAC-based ARP attack detection as 30.
<Sysname> system-view
[Sysname] arp source-mac threshold 30
display arp source-mac
Use display arp source-mac to display ARP attack entries detected by source MAC-based ARP attack
detection.
Syntax
MSR1000/MSR2000/MSR3000:
display arp source-mac [ interface interface-type interface-number ]
MSR4000:
display arp source-mac { slot slot-number | interface interface-type interface-number }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
slot slot-number: Specifies a card by its slot number. (MSR4000)
Usage guidelines
On an MSR1000/MSR2000/MSR3000 router, if you do not specify any interface, the display arp
source-mac command displays ARP attack entries detected on all interfaces.
Examples
# Display the ARP attack entries detected by source MAC-based ARP attack detection.
<Sysname> display arp source-mac
Source-MAC VLAN ID Interface Aging-time
23f3-1122-3344 4094 GE2/1/1 10
23f3-1122-3355 4094 GE2/1/2 30
23f3-1122-33ff 4094 GE2/1/3 25
23f3-1122-33ad 4094 GE2/1/4 30
To Next Page
Loading...
Need help?
General
