361
Views
IKE profile view
Predefined user roles
network-admin
Parameters
aggressive: Specifies the aggressive mode.
main: Specifies the main mode.
Usage guidelines
When a user at the local end of an IPsec tunnel obtains an IP address automatically and pre-shared key
authentication is used, HP recommends specifying the aggressive mode at the local end.
Examples
# Specify that IKE negotiation operates in main mode.
<Sysname> system-view
[Sysname] ike profile 1
[Sysname-ike-profile-1] exchange-mode main
Related commands
display ike proposal
ike dpd
Use ike dpd to enable sending DPD messages.
Use undo ike dpd to disable the DPD feature.
Syntax
ike dpd interval interval-seconds [ retry seconds ] { on-demand | periodic }
undo ike dpd interval
Default
IKE DPD is disabled.
Views
System view
Predefined user roles
network-admin
Parameters
interval interval-seconds: Specifies a period of time in seconds. The value range is from 1 to 300.
• If the on-demand keyword is specified, this parameter specifies the number of seconds during
which no IPsec packet is received before DPD is triggered if the local end has IPsec traffic to send.
• If the periodic keyword is specified, this parameter specifies a DPD triggering interval.
retry seconds: Specifies the number of seconds between DPD retries if the DPD message fails. The value
for the second argument is from 1 to 60 seconds, and it defaults to 5 seconds.
on-demand: Sends DPD messages on demand.
To Next Page
Loading...
Need help?
General
