EasyManuals Logo
Home>HP>Network Router>MSR SERIES

HP MSR SERIES Command Reference

HP MSR SERIES
684 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #373 background imageLoading...
Page #373 background image
359
Parameters
interval interval-seconds: Specifies a period of time in seconds. The value range is from 1 to 300.
• If the on-demand keyword is specified, this parameter specifies the number of seconds during
which no IPsec packet is received before DPD is triggered if the local end has IPsec traffic to send.
• If the periodic keyword is specified, this parameter specifies a DPD triggering interval.
retry seconds: Specifies the number of seconds between DPD retries if the DPD message fails. The value
for the second argument is from 1 to 60 seconds, and it defaults to 5 seconds.
on-demand: Sends DPD messages on demand.
periodic: Sends DPD messages at regular intervals.
Usage guidelines
DPD is triggered periodically or on-demand. The on-demand mode is recommended when the device
communicates with a large number of IKE peers. For an earlier detection of dead peers, use the periodic
triggering mode, which consumes more bandwidth and CPU.
When DPD settings are configured in both IKE profile view and system view, the DPD settings in IKE
profile view apply. If DPD is not configured in IKE profile view, the DPD settings in system view apply.
It is a good practice to set the triggering interval longer than the retry interval so that a DPD detection
does not occur during a DPD retry.
Examples
# Configure DPD to be triggered every 10 seconds and every 5 seconds between retries if the peer does
not respond.
<Sysname> system-view
[Sysname] ike profile 1
[Sysname-ike-profile-1] dpd interval 10 retry 5 on-demand
Related commands
ike dpd
encryption-algorithm
Use encryption-algorithm to specify an encryption algorithm for an IKE proposal.
Use undo encryption-algorithm to restore the default.
Syntax
In non-FIPS mode:
encryption-algorithm { 3des-cbc | aes-cbc-128 | aes-cbc-192 | aes-cbc-256 | des-cbc }
undo encryption-algorithm
In FIPS mode:
encryption-algorithm { aes-cbc-128 | aes-cbc-192 | aes-cbc-256 }
undo encryption-algorithm
Default
In non-FIPS mode, an IKE proposal uses the 56-bit DES encryption algorithm in CBC mode.
In FIPS mode, an IKE proposal uses the 128-bit AES encryption algorithm in CBC mode.

Table of Contents

Other manuals for HP MSR SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP MSR SERIES and is the answer not in the manual?

HP MSR SERIES Specifications

General IconGeneral
BrandHP
ModelMSR SERIES
CategoryNetwork Router
LanguageEnglish

Related product manuals