60
username name: Specifies the username in the detection packets. The name argument is a case-sensitive
string of 1 to 253 characters.
interval interval: Specifies the interval for sending a detection packet, in minutes. The value range for the
interval argument is 1 to 3600, and the default value is 60.
Usage guidelines
You can execute this command multiple times to configure multiple test profiles.
If you specify a non-existent test profile for a RADIUS server, the device does not detect the status of the
server until you create the test profile on the device.
You can specify the same test profile for multiple RADIUS servers.
When you delete a test profile, the device stops detecting the status of the RADIUS servers that use the test
profile.
Examples
# Configure test profile abc for RADIUS server status detection. The detection packet uses admin as the
username and is sent every 10 minutes.
<Sysname> system-view
[Sysname] radius-server test-profile abc username admin interval 10
Related commands
• primary authentication (RADIUS scheme view)
• secondary authentication (RADIUS scheme view)
radius dynamic-author server
Use radius dynamic-author server to enable the RADIUS DAE server feature and enter RADIUS DAE
server view.
Use undo radius dynamic-author server to restore the default.
Syntax
radius dynamic-author server
undo radius dynamic-author server
Default
The RADIUS DAE server feature is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
When you enable the RADIUS DAE server feature, the device listens to UDP port 3799 to receive DAE
packets from specified DAE clients.
Examples
# Enable the RADIUS DAE server feature and enter RADIUS DAE server view.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
