503
ipv6 address: Specifies the IPv6 address object group.
port: Specifies the port object group.
service: Specifies the service object group.
default: Specifies the default object group.
name object-group-name: Specifies an object group by its name, a case-insensitive string of 1 to 31
characters.
Examples
# Display information about all object groups.
<Sysname> display object-group
IP address object group obj1: 0 object(in use)
IP address object group obj2: 5 objects(out of use)
0 network host address 1.1.1.1
10 network host name host
20 network subnet 1.1.1.1 255.255.255.0
30 network range 1.1.1.1 1.1.1.2
40 network group-object obj1
Ipv6 address object-group obj3: 0 object(in use)
Ipv6 address object-group obj4: 5 objects(out of use)
0 network host address 1::1:1
10 network host name host
20 network subnet 1::1:0 112
30 network range 1::1:1 1::1:2
40 network group-object obj3
Service object-group obj5: 0 object(in use)
Service object-group obj6: 6 objects(out of use)
0 service 200
10 service tcp source lt 50 destination range 30 40
20 service udp source range 30 40 destination gt 30
30 service icmp 20 20
40 service icmpv6 20 20
50 service group-object obj5
Port object-group obj7: 0 object(in use)
Port object-group obj8: 3 objects(out of use)
0 port lt 20
10 port range 20 30
20 port group-object obj7
# Display information about object group obj2.
<Sysname> display object-group name obj2
Ip address object-group obj2: 5 objects(out of use)
To Next Page
Loading...
Need help?
General
