HP StorageWorks SN6000 Command Line Interface Guide

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 109
To display the Call Home service configuration, enter the show setup callhome command, as shown
in the following example.
SN6000 FC Switch (admin) #> show setup callhome
Callhome Information
--------------------
PrimarySMTPServerAddr 0.0.0.0
PrimarySMTPServerPort 25
PrimarySMTPServerEnabled False
SecondarySMTPServerAddr 0.0.0.0
SecondarySMTPServerPort 25
SecondarySMTPServerEnabled False
ContactEmailAddress nobody@localhost.localdomain
PhoneNumber <undefined>
StreetAddress <undefined>
FromEmailAddress nobody@localhost.localdomain
ReplyToEmailAddress nobody@localhost.localdomain
ThrottleDupsEnabled True
+ indicates active SMTP server
Managing the Call Home database
To modify the Call Home database:
1. Open an Admin session with the admin start command. An Admin session prevents other accounts
from making changes at the same time through Telnet, QuickTools, Simple SAN Connection Manager,
Enterprise Fabric Management Suite, or any other management application.
SN6000 FC Switch #> admin start
2. Open a Callhome Edit session with the callhome edit command. The Callhome Edit session
provides access to the profile, callhome, and capture commands that are used to make
modifications to the Call Home database.
SN6000 FC Switch (admin) #> callhome edit
SN6000 FC Switch (admin-callhome)#> callhome . . .
SN6000 FC Switch (admin-callhome)#> profile . . .
SN6000 FC Switch (admin-callhome)#> capture . . .
3. When you finish making changes, take one of the following actions:
• To save the changes and close the Callhome Edit session, enter the callhome save command.
Changes take effect immediately.
SN6000 FC Switch (admin-callhome)#> callhome save
• To close the Callhome Edit session without saving changes, enter the callhome cancel
command.
SN6000 FC Switch (admin-callhome)#> callhome cancel
4. To release the Admin session for other administrators, enter the admin end command.
To remove all Call Home profiles and restore the Call Home service configuration to its factory state, enter
the reset callhome command.
SN6000 FC Switch (admin) #> reset callhome

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English