HP StorageWorks SN6000 Command Line Interface Guide

180 Command Reference
reset
Description Resets the switch configuration parameters. If you omit the operand, the default is reset switch.
Authority Admin session
Syntax
reset
callhome
config [config_name]
factory
ipsec
port [port_list]
radius
security
services
snmp
switch (default)
system
zoning
Operands
callhome
Resets the Call Home database configuration to its default values.
config [config_name]
Resets the configuration given by [config_name] to the factory default values for switch, port, port
threshold alarm, and zoning configuration as described in Table 17 through Table 30. If
[config_name] does not exist on the switch, a configuration with that name will be created. If you
omit [config_name], the active configuration is reset. You must activate the configuration for the
changes to take effect.
factory
Resets switch configuration, port configuration, port threshold alarm configuration, zoning
configuration, SNMP configuration, system configuration, security configuration, RADIUS
configuration, switch services configuration, zoning configuration, and Call Home configuration
to the factory default values as described in Table 17 through Table 30. The switch configuration
is activated automatically.
NOTE: Because this operand changes network parameters, the workstation could lose
communication with the switch and release the Admin session.
This operand does not affect installed license keys.
ipsec
Resets the IP security database configuration to its default values.
port [port_list]
Reinitializes one or more ports given by [port_list]. [port_list] can be a set of port numbers and
ranges delimited by spaces. For example, 0 2 10-15 specifies ports 0, 2, 10, 11, 12, 13, 14,
and 15.
radius
Resets the RADIUS configuration to the default values as described in Table 22.
security
Clears the security database and deactivates the active security set. The security configuration
value, autosave, and fabric binding remain unchanged.
services
Resets the switch services configuration to the default values as described in Table 23.
snmp
Resets the SNMP configuration settings to the factory default values. See Table 21 for SNMP
configuration default values.

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English