HP StorageWorks SN6000 Command Line Interface Guide

12 Command Line Interface Usage
To log in to a switch through the serial port:
1. Configure the workstation port with the following settings:
•9,600 baud
• 8-bit character
•1 stop bit
• No parity
2. Enter an account name and password when prompted. The default account name is admin, and its
password is password.
NOTE: A switch supports a combined maximum of 19 logins or sessions, which are reserved as follows:
• 4 logins or sessions for internal applications, such as management server and Simple Network
Management Protocol (SNMP)
• 9 high priority Telnet sessions
• 6 logins or sessions for Simple SAN Connection Manager (SSCM) inband and out-of-band logins,
QuickTools logins, Enterprise Fabric Management Suite logins, and Telnet logins.
Additional logins will be refused.
Opening and closing an admin session
The command line interface (CLI) performs monitoring and configuration tasks. Commands that perform
monitoring tasks are available to all user accounts. Commands that perform configuration tasks are
available only after entering the admin start command to open an Admin session. A user account must
have Admin authority to enter the admin start command.
The following is an example of how to open and close an Admin session:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #>
.
.
.
SN6000 FC Switch (admin) #> admin end
Entering commands
The command-line completion feature makes entering and repeating commands easier. Table 1 describes
the command-line completion keystrokes.
Table 1 Command-line completion
Keystroke Effect
Tab Completes the command line. Enter at least one character and press the
tab key to complete the command line. If more than one possibility
exists, press the Tab key again to display all possibilities.
Up Arrow Scrolls backward through the list of previously entered commands.
Down Arrow Scrolls forward through the list of previously entered commands.
Control-A Moves the cursor to the beginning of the command line
Control-E Moves the cursor to the end of the command line.
Control-U Clears the command line.

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English