206 Command Reference
set log
Description Specifies the events to record in the event log and display on the screen. You determine what events
to record in the switch event log using the component, level, and port operands. You determine
what events are automatically displayed on the screen using the display operand. Alarms are
always displayed on the screen.
Authority Admin session
Syntax
set log
archive
clear
component [filter_list]
display [filter]
level [filter]
port [port_list]
restore
save
start (default)
stop
Operands
archive
Collects all log entries and stores the result in new file named logfile that is maintained in
switch memory where it can be downloaded using FTP. To download logfile, open an FTP
session, log in with account name/password of images for both, and type get logfile.
clear
Clears all log entries.
component [filter_list]
Specifies one or more components given by [filter_list] to monitor for events. A component is a
firmware module that is responsible for a particular portion of switch operation. Use a <space>
to delimit values in the list. Table 39 describes the component event monitoring filter parameters.
Table 39 Component event monitoring filter parameters
Parameter Description
All Monitors all components. To maintain optimal switch performance, do not use
this setting with the level operand set to info.
Eport Monitors all E_Ports
Mgmtserver Monitors management server status
Nameserver Monitors name server status
None Monitor none of the component events
Port Monitors all port events
Qfs Monitors Call Home service events
Snmp Monitors all SNMP events
Switch Monitors switch management events
Zoning Monitors zoning conflict events
display [filter]
Specifies the log events to automatically display on the screen according to the event severity
levels given by [filter]. Table 40 describes the event display filter parameters.
To Next Page
Loading...
Need help?
General