HP StorageWorks SN6000 Command Line Interface Guide

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 49
Setting the time through an NTP server
An NTP server can automatically set the switch date and time. To configure the switch to use an NTP server,
enter the set setup system ntp command in an Admin session to enable the NTP client on the switch
and specify the NTP server IP address, as shown in the following example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> set setup system ntp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
NTPClientEnabled False
NTPServerDiscovery Static
NTPServerAddress 10.20.10.10
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
NTPClientEnabled (True / False) : True
NTPServerDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :
NTPServerAddress (hostname, IPv4, or IPv6 Address) : 10.20.3.4
Do you want to save and activate this system setup? (y/n): [n] y
Resetting a switch
Table 4 describes the methods for resetting a switch, the corresponding command, and the impact on the
switch.
Table 4 Switch reset methods
Description Hot reset
hotreset
command
Soft reset
reset switch
command
Hard reset
hardreset
command
Activates pending firmware X X X
Disrupts I/O traffic X X
Reconnects Simple SAN
Connection Manager, QuickTools,
and Enterprise Fabric Management
Suite sessions afterwards
XXX
Clears the event log X X X
Deletes supports files, firmware
image files that have not been
unpacked, and configuration
backup files
XX
Closes all management sessions X X X
Performs power-on self test (POST) X

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English