HP StorageWorks SN6000 Command Line Interface Guide

98 RADIUS Server Configuration
Configuring a RADIUS server on the switch
To configure a RADIUS server on the switch, enter the set setup radius command. There are two
groups of RADIUS configuration parameters. One group of parameters is common to all RADIUS server
configurations. The second group is server-specific. You can configure both groups of parameters for all
RADIUS servers, or you can configure the common and server-specific parameters separately. See
Table 47 and Table 48 for descriptions of the common and server-specific RADIUS configuration
parameters.
The following example configures the common RADIUS server configuration parameters:
SN6000 FC Switch (admin) #> set setup radius common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
PLEASE NOTE:
-----------
* SSL must be enabled in order to configure RADIUS User Authentication
SSL can be enabled using the 'set setup services' command.
Current Values:
DeviceAuthOrder Local
UserAuthOrder Local
TotalServers 1
New Value (press ENTER to not specify value, 'q' to quit):
DeviceAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :
UserAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :
TotalServers decimal value, 0-5 :
Do you want to save and activate this radius setup? (y/n): [n]

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English