HP StorageWorks SN6000 Command Line Interface Guide

HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 23
IPv6 configuration
The switch supports IPv6, which includes the following:
• Network discovery method
• IP address
• IP gateway address
The network discovery method determines how the switch acquires its IP address. The IP address can come
from the IP address (static) that resides on the switch or from a DHCP server; or it can be learned from
a router through the Neighbor Discovery Protocol (NDP). To configure the IPv6 parameters, enter the
set setup system ipv6 command:
SN6000 FC Switch (admin) #> set setup system ipv6
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
EthIPv6NetworkEnable False
EthIPv6Discovery Static
EthIPv6NetworkAddress <undefined>
EthIPv6GatewayAddress <undefined>
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
EthIPv6NetworkEnable (True / False) :
EthIPv6Discovery (1=Static, 2=Dhcpv6, 3=Ndp) :
EthIPv6NetworkAddress (IPv6 Address/Mask Length format) :
EthIPv6GatewayAddress (IPv6 Address) :
Do you want to save and activate this system setup? (y/n): [n]

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English