HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 33
Renaming a user-defined association
To rename a user-defined association (association_1), enter the ipsec association rename
command as shown in the following example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> ipsec edit
SN6000 FC Switch (admin-ipsec) #> ipsec association rename association_1
association_4
The security association will be renamed. Please confirm (y/n): [n] y
SN6000 FC Switch (admin-ipsec) #> ipsec save
The IPsec configuration will be saved and activated.
Please confirm (y/n): [n] y
Copying an association
You can copy both user-defined and dynamic associations. To copy an association (association_1),
enter the ipsec association copy command as shown in the following example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> ipsec edit
SN6000 FC Switch (admin-ipsec) #> ipsec association copy association_1 association_a
SN6000 FC Switch (admin-ipsec) #> ipsec save
The IPsec configuration will be saved and activated.
Please confirm (y/n): [n] y
Resetting the IP security configuration
Resetting the IP security configuration deletes all policies and associations from the switch. You can use
either the ipsec clear command or the reset ipsec command to do this. In an Ipsec Edit session,
enter the ipsec clear command, then save the changes as shown in the following example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> ipsec edit
SN6000 FC Switch (admin-ipsec) #> ipsec clear
SN6000 FC Switch (admin-ipsec) #> ipsec save
The IPsec configuration will be saved and activated.
Please confirm (y/n): [n] y
The reset ipsec command deletes all polices and associations from the switch, but does not require an
Ipsec Edit session.
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> reset ipsec
The IPsec configuration will be reset and the default values activated.
Please confirm (y/n): [n] y
Reset and activation in progress ....
To Next Page
Loading...
Need help?
General