HP StorageWorks SN6000 Command Line Interface Guide

200 Command Reference
set config security portbinding
Description Configures port binding.
Authority Admin session and a Config Edit session
Syntax
set config security portbinding [port_number]
Operands
[port_number]
Initiates an editing session in which to change the port binding configuration for the port given by
[port_number]. The system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press Enter to accept the current value shown in brackets.
Enter q or Q to end the editing session. Table 35 describes the set config security
portbinding parameters.
Table 35 Port binding configuration parameters
Parameter Description
PortBindingEnabled Enables (True) or disables (False) port binding for the port
given by [port_number]. The default is False.
WWN Worldwide port name for the port/device that is allowed to
connect to the port given by [port_number].
Examples The following is an example of the set config security portbinding command:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) config edit
SN6000 FC Switch (admin-config) #> set config security portbinding 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PortBindingEnabled (True / False)[False] true
WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f9
WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f8
WWN (N=None / WWN)[None ] n
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
See also show config security portbinding, page 239

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English