120 Simple Network Management Protocol Configuration
The following example configures SNMP trap 1:
SN6000 FC Switch (admin) #> set setup snmp trap 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
Trap1Enabled True
Trap1Address 10.20.33.181
Trap1Port 5001
Trap1Severity info
Trap1Version 2
Trap1Community northdakota
New Value (press ENTER to not specify value, 'q' to quit):
Trap1Enabled (True / False) :
Trap1Address (hostname, IPv4, or IPv6 Address) :
Trap1Port (decimal value, 1-65535) :
Trap1Severity (select a severity level)
1=unknown 6=warning
2=emergency 7=notify
3=alert 8=info
4=critical 9=debug
5=error 10=mark :
Trap1Version (1 / 2) :
Trap1Community (string, max=32 chars) :
Do you want to save and activate this snmp setup? (y/n): [n]
Resetting the SNMP configuration
To reset the SNMP configuration back to the factory defaults, enter the reset snmp command in an
Admin session, as shown in the following example. See Table 21 for a listing of the SNMP configuration
factory defaults.
SN6000 FC Switch (admin) #> reset snmp
To Next Page
Loading...
Need help?
General