HP StorageWorks SN6000 Command Line Interface Guide

220 Command Reference
Operands
trap [trap_number]
Prompts you in a line-by-line fashion to change SNMP trap parameters for the trap number given
by [trap_number]. [trap_number] can be 1–5. For each parameter, enter a new value or press
Enter to accept the current value. To configure common parameters and trap parameters, omit the
trap operand. Table 51 describes the trap parameters.
Table 51 SNMP trap configuration parameters
Parameter Description
Trap [1-5] Address Specifies the workstation IP address to which SNMP traps are sent. The
default address for trap 1 is 10.0.0.254. The default address for traps
2–5 is 0.0.0.0. Addresses, other than 0.0.0.0, for all traps must be
unique.
Trap [1-5] Port Specifies the workstation port to which SNMP traps are sent. Valid
workstation port numbers are 1–65535. The default is 162.
Trap [1-5] Severity Specifies the severity level to use when monitoring trap events. The
default is Warning.
Trap [1-5] Version Specifies the SNMP version (1 or 2) to use in formatting traps. The
default is 2.
Trap [1-5] Enabled Specifies whether traps (event information) are enabled (True) or
disabled (False). The default is False.
Examples The following is an example of the set setup snmp common command:
SN6000 FC Switch (admin) #> set setup snmp common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
SnmpEnabled True
Contact <sysContact undefined>
Location <sysLocation undefined>
ReadCommunity public
WriteCommunity private
AuthFailureTrap False
ProxyEnabled True
SNMPv3Enabled False
New Value (press ENTER to not specify value, 'q' to quit):
SnmpEnabled (True / False) :
Contact (string, max=64 chars) :
Location (string, max=64 chars) :
ReadCommunity (string, max=32 chars) :
WriteCommunity (string, max=32 chars) :
AuthFailureTrap (True / False) :
ProxyEnabled (True / False) :
SNMPv3Enabled (True / False) :
Do you want to save and activate this snmp setup? (y/n): [n]

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English