HP StorageWorks SN6000 Command Line Interface Guide

274 Command Reference
show switch
Description Displays switch operational information.
Authority None
Syntax
show switch
Notes Table 65 describes the switch operational parameters.
Table 65 Switch operational parameters
Parameter Description
SymbolicName Descriptive name for the switch
SwitchWWN Switch worldwide name
BootVersion Programmable Read-only Memory (PROM) boot version
CreditPool Number of port buffer credits available to recipient ports
DomainID Switch domain ID
FirstPortAddress Fibre Channel address of switch port 0
FlashSize - MBytes Size of the flash memory, in megabytes
LogFilterLevel Event severity level, used to record events in the event log
MaxPorts Number of ports available on the switch
NumberOfResets Number of times the switch has been reset over its service
life
ReasonForLastReset Action that caused the last reset
ActiveImageVersion-build
date
Active firmware image version and build date
PendingImageVersion-build
date
Firmware image version and build date that is pending.
This image will become active at the next reset or
power-cycle.
ActiveConfiguration Name of the switch configuration that is in use.
AdminState Switch administrative state
AdminModeActive Admin session status
BeaconOnStatus Beacon status as set by the set beacon command
OperationalState Switch operational state
PrincipalSwitchRole Principal switch status. True indicates that this switch is the
principal switch.
POSTFaultCode Fault code from the most recent power-on self test
POSTStatus Status from the most recent power-on self test
TestFaultCode Fault code from the most recent switch test
TestStatus Status from the most recent switch test
BoardTemp (1) - Degrees
Celsius
Internal switch temperature at circuit board sensor 1
SwitchTemperatureStatus Normal, warning, failure

HP StorageWorks SN6000 Specifications

General

Brand	HP
Model	StorageWorks SN6000
Category	Switch
Language	English