154
Step Remarks
3. Adding a blacklist entry manually
You can add blacklist entries manually, or enable the blacklist
function globally, configure the scanning attack protection function,
and enable the blacklist function for scanning attack protection to
allow the device to add the IP addresses of detected scanning
attackers to the blacklist automatically. For configuration of
scanning attack protection, see "
Configuring intrusion detection
."
By
default, no blacklist entry exists.
IMPORTANT:
Modifying an automatically added entry will change the type of the
entry to Manual.
4. Viewing blacklist entries
Optional.
Enabling the blacklist function
From the navigation tree, select Security Setup > Attack Defend > Blacklist to enter the page
shown in Figure 160, where
all manually config
ured or automatically generated blacklist entries are
listed. Select the box before Enable Blacklist and click Apply to enable the blacklist filtering
function.
Figure 160 Blacklist page
Adding a blacklist entry manually
On the blacklist page shown in Figure 160, click Add to configure a blacklist entry, as shown in Figure
161.
Figure 161 Add a blacklist entry
To Next Page
Loading...
Need help?
General
