HPE FlexNetwork MSR Series User Manual

311
Configuring media parameters for SIP-to-SIP connections
1. Select Voice Management > Call Route from the navigation tree.
2. Click the icon of the call route to be configured.
The page for configuring SIP-to-SIP connection parameters appears.
Figure 701 Configuring media parameters
3. Configure media parameters for SIP-to-SIP connections as described in Table 263.
Table 263 Configuration items
Item Description
Codec Transparent
If the SIP trunk device does not support the codec capability sets
supported by the calling and called parties, you can select the
Enable
option to enable codec transparent transfer on the SIP
trunk device. The SIP trunk device transparently transfers codec
capability sets between two parties. The calling and called parties
complete the codec negotiation.
By default, the
Disable
option is selected.
Codec Transcoding
In the scenario where the SIP trunk device controls the results of
media capability negotiation, if the SIP trunk device cannot find a
common codec for two parties during negotiation, the two parties
will fail to establish a call. In this case, you can select the
Enable
option to enable codec transcoding on the SIP trunk device.
With this function enabled, the SIP trunk device uses its own
codec capability set to negotiate with the calling and called parties
respectively. If the negotiated codecs with the two parties do not
match, the SIP trunk device transcodes the media flows passing
through it.
By default, the
Disable
option is selected.
IMPORTANT:
The codec transcoding feature does not take effect in any of the
following cases:
• Codec transcoding is enabled, but no DSP resources are
available for codec transcoding.
• Codec transparent transfer is enabled.
• Media flow-around is enabled.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English