164
Configuring application control
You can load applications, configure a custom application, and enable application control in the Web
interface.
Application control allows you to control which applications and protocols users can access on the
Internet by specifying the destination IP address, protocol, operation type, and port. Application
control can be based on a group of users or all users in a LAN. This chapter describes the application
control based on all users. For application control based on user group, see "Configuring user
groups."
The application control function applies to only the outbound direction of WAN interfaces.
Recommended configuration procedure
Step Remarks
1. Loading applications
Optional.
Load the signature file that contains the application control rules to
the device.
IMPORTANT:
If you perform this configuration for multiple times, only the last file
loaded to the device takes effect.
2. Configuring a custom application
Optional.
Add a custom application and configure the match rules.
3. Enabling application control
Required.
Enable application control for specified applications or protocols
globally.
Loading applications
Select Security Setup > Application Control from the navigation tree, and then select the Load
Application tab to enter the page for loading applications, as shown in Figure 175.
• T
o
load an application control file from the device, select From Device, select the application
control file, and then click Apply.
• To load an application control file from the local host to the device, select From Local, click
Browse to find the file, and then click Apply.
After the file is loaded to the device successfully, all the loaded applications will be displayed at the
lower part of the page.
To Next Page
Loading...
Need help?
General
