HPE FlexNetwork MSR Series User Manual

229
Item Description
Packet Assembly Interval
of G726r32
Specify the packet assembly interval for g726r32 codec.
Packet Assembly Interval
of G726r40
Specify the packet assembly interval for g726r40 codec.
Packet Assembly Interval
of G729
Specify the packet assembly interval for g729r8, g729br8, and g729a codecs.
Two communication parties can communicate correctly only if they share some identical
coding/decoding algorithms. If the codec algorithm between two connected devices is inconsistent,
or the two devices share no common coding/decoding algorithms, the calling fails.
Configuring other parameters of a local number
Select Voice Management > Local Number from the navigation tree, and then click the icon of
the local number to be configured to access the advanced settings configuration page.
Figure 610 Configuring other parameters of the local number
Table 227 Configuration items
Item Description
Number Selection Priority
Set the priority of the local number. The smaller the value, the
higher the priority.
Dial Prefix
Configure a dial prefix for the local number. For a trunk type call
route, the dial prefix is added to the called number to be sent out.
Called Number
Sending Mode
Send a Truncated
Called Number
Send a truncated called number.
Send All Digits of
a Called Number
Send all digits of a called number.
Send Certain
Number of Digits
Send a certain number of digits (that are extracted from the end of
a number) of a called number. The specified value should be not
greater than the total number of digits of the called number.
DTMF
Transmission
In-band
Transmission
Specify the in-band SIP DTMF transmission mode.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English