41
Configuring WAN interfaces
This chapter describes how to configure the following interfaces on the Web interface:
• Ethernet interfaces.
• SA interfaces.
• ADSL/G.SHDSL interfaces.
• CE1/PRI interfaces.
• CT1/PRI interfaces.
Configuring an Ethernet interface
An Ethernet interface or subinterface supports the following connection modes:
• Auto—The interface acts as a DHCP client to get an IP address through DHCP.
• Manual—The IP address and subnet mask are configured manually for the interface.
• PPPoE—The interface acts as a PPPoE client. PPPoE provides access to the Internet for hosts
in an Ethernet through remote access devices. It also implements access control and
accounting on a per-host basis. As it is cost-effective, PPPoE gains popularity in various
applications, such as residential networks.
To configure an Ethernet interface:
1. Select Interface Setup > WAN Interface Setup from the navigation tree.
Figure 28 WAN interface configuration page
2. Click the icon for the Ethernet interface.
3. Configure the Ethernet interface, as described in Table 24, Table 25, and Table 26.
To Next Page
Loading...
Need help?
General
