Maintenance Guide
15-1
15 Solder Recognition and Placement Position
Correction
DANGER
To prevent any trouble caused by accidental machine start,
always shut-down the air and
the power before starting the
maintenance and adjustment work.
15-1 Replacing the Solder Recognition Light Board
1) Unscrew the flat head machine screws and remove the board spacer, LIGHT DIFFUSER
and the OCC O board.
2) Reassemble the components in reverse order.
3) After replacing the solder recognition light board with a new one, it is necessary to adjust the
solder recognition light.
OCC O board
Coaxial light board assembly
①
Angle light board
assembly
②
To Next Page
Loading...
Need help?
General
