Maintenance Guide
5-17
5-7-3 Replacing the Fiber Amplifier
(1) Assembling the fiber into the amplifier
1) Raise the lever on the top of the amplifier unit.
2) Insert the fiber into the amplifier unit completely until it is in contact with the far position,
and then lay down the lever.
Note) Assemble the light emitting side and light receiving side correctly without fail.
Note) Cut the top end with the cutter supplied with the fiber and insert the fiber sensor into
the amplifier.
Figure 5-7-3-1 Fiber Amplifier
(2) Detaching and attaching the amplifier unit
1) Push in the amplifier unit toward the fiber insertion side.
2) Raise the fiber insertion side with the amplifier unit kept pushed. The amplifier is then
detached.
3) When attaching the amplifier unit, hang the claw on the cable side on the DIN rail and
push in the fiber insertion side downward.
4) For details about fiber amplifier attaching order, see Figure 5-7-3-2.
Figure 5-7-3-2 Detaching and Attaching the Amplifier Unit
Table 5-7-3-1 Amplifier Unit Part Nos.
Amplifier unit Part No. Connector marker
For WAIT 1
40129061
For WAIT 2
40129061
For C-OUT
40129061
To Next Page
Loading...
Need help?
General
