1-29
1-5-3. Separating the Link
Follow the steps below to separate the link and detach it.
1-5-4. Connecting the Cableveyor
Replace the link and follow the steps below to connect the links.
1) Insert a slotted screwdriver
into the hole in the bottom of
the link (inner circumferences
2) Pry the slotted screwdriver in the direction indicated by an arrow
to detach the link.
Note) Use a slotted screwdriver with a tip blade width of 3.5 mm or less.
1) Detach the arms for two links
at both ends and arrange
2) Fit the convex part on the top
of the link into the concave
part of the adjacent link.
3) Fit the bottom of the link.
4) In the same manner, connect the links on the opposite side.
To Next Page
Loading...
Need help?
General
