Monitoring Redundant SFM Status ! 583
Chapter 44: Monitoring Redundant SFMs
Slot 1 information:
State Online - Standby
SPP Temperature 41 degrees C / 105 degrees F
SPR Temperature 40 degrees C / 104 degrees F
Total CPU DRAM 64 MB
Total SSRAM 8 MB
Internet Processor II Version 1, Foundry IBM, Part number 9
For M160 routers:
Slot 0 information:
State Online
SPP Temperature 39 degrees C / 102 degrees F
SPR Temperature 41 degrees C / 105 degrees F
Total CPU DRAM 64 MB
Total SSRAM 4 MB
Internet Processor I Version 1, Foundry IBM, Part number 3
Start time: 2002-06-27 18:49:44 PDT
Uptime: 68 days, 4 hours, 55 minutes, 5 seconds
Slot 1 information:
State Online
[...Output truncated...]
Slot 2 information:
State Offline
[...Output truncated...]
Slot 3 information:
State Online
[...Output truncated...]
Packet scheduling mode : Disabled
In addition to the command output displayed for the show chassis sfm command,
the
show chassis sfm detail command displays the temperature of air passing by
the SPP and SPR cards (the two SFM serial components), in degrees Centigrade. It
displays the total CPU DRAM and SRAM being used by the SFM processor. The
command output displays the time that the SFM became active and how long the
SFM has been up and running. A small uptime means that the SFM came online a
short time ago and could indicate a possible SFM error condition.
To display the status of a particular SFM, use the following CLI command:
user@host> show chassis sfm sfm-slot
To display detailed status information about a particular SFM, use the following CLI
command:
user@host> show chassis sfm detail sfm-slot
To Next Page
Loading...
Need help?
General
