Using the Basic Monitoring Method ! 59
Chapter 11: Understanding the Method and Tools for Monitoring Router Components
Display Detailed Component Environmental Information
(For M7i, M10i, M40e, M160, M320, and T320 routers and T640 routing node) You
can display detailed environmental status information about certain router
components.
Action To display detailed environmental status information about a component, use the
following CLI command:
user@host> show chassis environment component-name
The command output displays the temperature of the air passing by the
component, in degrees Centigrade and Fahrenheit. It also displays whether the fans
and/or blowers are at normal or high speed.
Table 18 lists the operational mode CLI commands for each router component for
which you can display more detailed information.
Table 18: Component Detailed Environmental Status CLI Commands
SCG (T320 router and T640 routing node) On the SCG faceplate at the
upper rear of the chassis.
SIB (M320, T320 router and T640 routing node) On the SIB faceplate at
the center rear of the chassis.
(M320 router) On the craft interface.
CFEB (M7i/M10i routers) On the DFEB faceplate at the rear of the router.
FIC (M7i router) On the FIC faceplate at front of the router.
HCM (M10i router) On the HCM faceplate at front of the router.
Component LED Location on the Router
Component Operational Mode CLI Command
FEB show chassis environment feb
FPC show chassis environment fpc
FPM or craft interface show chassis environment fpm
MCS show chassis environment mcs
PCG show chassis environment pcg
PEM or power supply show chassis environment pem
Routing Engine show chassis environment routing-engine
SFM show chassis environment sfm
Control Board show chassis environment cb
SIB show chassis environment sib
SCG show chassis environment scg
To Next Page
Loading...
Need help?
General
