Juniper JUNOS - NETWORK OPERATION GUIDE REV1 User Manual

JUNOS Internet Software Network Operations Guide: Hardware
638 ! CLI Operational Mode
mld Clear multicast listener discovery information
mpls Clear Multiprotocol Label Switching information
msdp Clear Multicast Source Discovery Protocol information
multicast Clear multicast information
ospf Clear Open Shortest Path First information
ospf3 Clear Open Shortest Path First version 3 information
pgm Clear Pragmatic Generalized Multicast information
pim Clear Protocol Independent Multicast information
rip Clear Routing Information Protocol information
ripng Clear Routing Information Protocol for IPv6 information
rsvp Clear Resource Reservation Protocol information
services
snmp Clear Simple Network Management Protocol information
system Clear system information
vpls Clear VPLS information
vrrp Clear Virtual Router Redundancy Protocol statistics
Having the CLI Complete Commands
You do not always have to remember or type the full command or option name for
the CLI to recognize it. To display all possible command or option completions, type
the partial command followed by a question mark.
To complete a command or option that you have partially typed, press the
Tab key
or the spacebar. If the partially typed letters begin a string that uniquely identifies a
command, the complete command name appears. Otherwise, a beep indicates that
you have entered an ambiguous command, and the possible completions are
displayed.
Command completion also applies to other strings, such as filenames and
usernames. To display all possible values, type a partial string followed by a
question mark. However, to complete these strings, press the
Tab key; pressing the
space bar does not work.
Using CLI Command Completion
To complete the show interfaces command, do the following:
user@host> show in<Spacebar>terfaces <Enter>
Physical interface: at-0/1/0, Enabled, Physical link is Up
Interface index: 11, SNMP ifIndex: 65
Link-level type: ATM-PVC, MTU: 4482, Clocking: Internal, SONET mode
Speed: OC12, Loopback: None, Payload scrambler: Enabled
Device flags : Present Running
Link flags : 0x01
[...Output truncated...]

Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Specifications

General

Brand	Juniper
Model	JUNOS - NETWORK OPERATION GUIDE REV1
Category	Software
Language	English