Using the Basic Monitoring Method ! 57
Chapter 11: Understanding the Method and Tools for Monitoring Router Components
! Physically look at the router craft interface. Table 16 shows the component
characteristics of each router craft interface.
Table 16: Router Craft Interface Component Characteristics
Check the Component LEDs
Action To check the component LED status, do one of the following:
! Use the following CLI command:
user@host> show chassis craft-interface
The command output displays the LED status for the following components:
! M7i/M10i/M20 router: Routing Engine and FPC
! M40e/M160 router: Routing Engine, FPC, MCS, PCG, and SFM
! M320 router: Routing Engine, FPC, Control Board, SIB, and power supply
(PS)
! T320 router and T640 routing node: Routing Engine, FPC, Control Board,
SCG, and SIB
Component
M5/
M10
M7i/
M10i
M20 M40 M40e M160 M320 T320 T640
Alarm LEDs X X X X X X X X X
Alarm cutoff/Lamp Test button
(AC)/LT)
XXX X XX XX
Alarm relay contacts X X X X
(in CIP)
X
(in CIP)
X
(in CIP)
X
(in CIP)
Link and activity status lights X X X X
(in CIP)
X
(in CIP)
X
(in CIP)
X
(in CIP)
LCD display and navigation
buttons
XX XX XX
Routing Engine ports X X X X
(in CIP)
X
(in CIP)
X
(in CIP)
X
(in CIP)
Routing Engine LEDs X X X
Host module LEDs X X
Host subsystem LEDs XX
PIC online and offline buttons X X
FPC LEDs
No Craft Interface
No Craft Interface
XXXXX XX
FPC offline buttons X X X X X X X
SIB LEDs XXX
Power supply LEDs X
To Next Page
Loading...
Need help?
General
