24 SERVICE SCHEDULE 184
24.1 Service schedule
Every 20,000 km (12,428 mi) or every 2 years
Every 10,000 km (6,214 mi) or annually or after every sporting use
Once after 1,000 km (621.4 mi)
Check that the electrical equipment is functioning correctly. ○ ● ●
Read out the fault memory using the KTM diagnostics tool. ○ ● ●
Check the measured service values with the KTM diagnostics tool. ● ●
Change the engine oil and filter, clean the oil screens. ( p. 167) ○ ● ●
Check the front brake linings. ( p. 85) ○ ● ●
Check the rear brake linings. ( p. 89) ○ ● ●
Check the brake discs. ( p. 69) ○ ● ●
Check the brake lines for damage and leakage. ○ ● ●
Check the rear brake fluid level. ( p. 91) ○ ● ●
Check the free travel of the foot brake lever. ( p. 91) ○ ● ●
Check that the shock absorber and fork are leak tight. If necessary and depending on use, service the fork and
shock absorber.
○ ● ●
Check the swingarm bearing. ● ●
Check the wheel bearing for play. ● ●
Check the tire condition. ( p. 68) ○ ● ●
Check the tire air pressure. ( p. 68) ○ ● ●
Check the spoke tension. ( p. 69) ○ ● ●
Check for rim run-out. ○ ● ●
Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 75) ● ●
Check the chain tension. ( p. 74) ○ ● ●
Grease all moving parts (e.g. side stand, hand lever, chain, ...) and check for smooth operation. ○ ● ●
Clean the dust boots of the fork legs. ( p. 15) ● ●
Check the front brake fluid level. ( p. 86) ○ ● ●
Bleed the fork legs. ( p. 14) ● ●
Check the steering head bearing play. ( p. 27) ○ ● ●
Change the spark plug. ●
Check the valve clearance. ● ●
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks, and incorrect routing. ●
Check the antifreeze and coolant level. ( p. 163) ○ ● ●
Check the cables for damage and routing without sharp bends. ● ●
Check that the throttle cables are undamaged, routed without sharp bends and set correctly. ○ ● ●
Change the air filter. Clean the air filter box. ● ●
Check the fuel pressure. ● ●
Check the CO adjustment with the KTM diagnostics tool. ● ●
Check/rectify the fluid level of the hydraulic clutch. ( p. 161) ● ●
Check the screws and nuts for tightness. ○ ● ●
Change the rear brake fluid. ( p. 93) ●
Change the rear brake fluid. ( p. 93) ●
Check the clutch. ●
Check the headlight setting. ( p. 97) ○ ● ●
Check that the radiator fan is functioning properly. ○ ● ●
Final check: Check the vehicle for roadworthiness and take a test ride. ○ ● ●
Read out the fault memory using the KTM diagnostics tool after a test ride. ○ ● ●
Make the service entry in KTM DEALER.NET and in the service record. ○ ● ●
○ One-time interval
● Periodic interval
To Next Page
Loading...
Need help?
General
